This is the PCB for my second custom CMoy build. It uses a pair of WIMA MKP 10 as input capacitors and is ready to be installed on my recently finished Hammond 70009 enclosure.
Read more...
This is the part list used in this build:
- Power section:
- 1 x Panasonic FC 470uF. 25V. electrolythic capacitor.
- 1 x Texas Instruments TLE2426CP rail splitter.
- 1 x DIP8 socket.
- 1 x Generic 1uF. 63V. polyester capacitor (TLE noise reduction).
- 3 x Molex KK 2 pin vertical male connectors (power input connector, power switch connector and LED connector).
- Op-Amp section:
- 2 x WIMA MKP 10 - 0.47uF. 400V. - Polypropylene (PP) film dielectric (input capacitors).
- 1 x Texas Instruments / Burr-Brown OPA2134PA Op-Amp.
- 2 x Generic 0.1uF. 100V. polyester capacitor (Op-Amp decoupling capacitors).
- 1 x DIP8 socket.
- 2 x Molex KK 3 pin vertical male connectors (audio input / output connectors).
- 1 x Molex KK 2 pin vertical male connectors (ground connector).
- 2 x Generic 100K. 1/4W. resistor.
- 2 x Generic 10K. 1/4W. resistor.
- 2 x Generic 2.2K. 1/4W. resistor.
And here are the
schematics: